Open wall studs with new red and blue PEX pipes after a whole-house repipe
24/7 Emergency Line Open

Repiping in Ballwin, MO

Repiping in Ballwin, MO replaces worn supply lines with new pipe, either throughout the house or one section at a time. Call (314) 461-6239 and describe the symptoms, such as low pressure, discolored water or repeated leaks.

If a pipe has already burst, close the main valve and use the burst pipe repair page. Repiping itself is planned and quoted ahead.

  • Whole-house repipe
  • Partial repiping
  • Galvanized replacement
  • Polybutylene removal
  • 24/7 dispatchNights, weekends and holidays
  • Clear price before work startsYou approve it first
  • Licensed and insuredPlumbers serving St. Louis County
  • Same-day appointmentsWhen available

Signs your supply pipes are wearing out

Supply pipes rarely fail without warning. Pressure drops at the far end of the house, water runs brown for a minute after sitting, or a pinhole leak shows in a wall or the basement ceiling. When a second pinhole follows the first, the pipe has usually thinned along its whole length.

Common signs

  • Low water pressure that cleaning aerators does not fix
  • Rusty or discolored water from the tap
  • Pinhole leaks or green stains on copper
  • Visible corrosion on exposed basement lines
  • Repeated repairs in the same run

Pipe materials found in older homes

Materials and their issues
MaterialTypical issueRepiping advice
Galvanized steelRust inside narrows the pipeReplace when pressure and color decline
CopperPinholes from water chemistry or ageRepair or replace by section
Polybutylene (gray plastic)Fittings can fail, installed roughly 1978 to 1995Plan replacement
PEXModern, flexible, resists freezing damageUsed for most new work

Ballwin's population doubled in both the 1960s and the 1980s, so homes here cover several eras of piping. Look at the pipe where it enters the basement to see which material you have, and send the dispatcher a photo if you can.

Thinking about repiping? Call and talk to a licensed plumber.

Call (314) 461-6239

Whole house or one section

A partial repipe replaces the worst run, such as a kitchen branch or the line to a second-floor bath. It costs less and fits a tight budget. A whole-house repipe replaces everything from the main to every fixture, and it is worth considering if leaks keep returning in different places.

A new main line from the meter is a separate decision. The utility and the owner each own part of the service connection, so ask Missouri American Water where your section starts. If the leak is between the curb and the house, leak detection confirms where it is first.

How a repipe is done

  1. 01

    Survey

    The plumber maps existing lines, pressure and fixtures, then proposes a route.

  2. 02

    Rough in

    New lines are run through walls, floors and the basement with as few openings as possible.

  3. 03

    Connect and test

    Fixtures are reconnected and the system is pressure tested.

  4. 04

    Patch and clean

    Small access openings are covered for drywall repair, and the work area is cleaned.

Water service is usually off for part of a day. We plan the order so a kitchen or bath stays usable where we can, and we tell you the schedule ahead.

Permits and inspection

The City of Ballwin says plumbing permits are typically needed for work such as basement finishing and that building permits apply to construction. Call Building Inspections at (636) 227-2129 to confirm what your repipe needs. We follow the answer.

What changes the price of repiping

Cost factors we explain before work starts

  • House size and layoutMore fixtures and floors mean more pipe and labor.
  • Material choicePEX and copper differ in material and labor cost.
  • AccessFinished walls, slabs and ceilings add patching.
  • ScopeA partial run costs far less than a whole house.
  • PermitsPermit fees and inspections vary.

Planned repiping is not covered by homeowner insurance, though a sudden leak may be. Call (314) 461-6239 for your actual number.

Standards note: New supply pipe must meet the International Plumbing Code (IPC) for materials, and the plumber tests the system under pressure before closing walls. The City of Ballwin lists the International Plumbing Code among its adopted codes, and the Building Inspections Department at (636) 227-2129 can confirm which edition applies.

Repiping questions from Ballwin homeowners

A partial repipe can take a day. A whole-house job often takes several days, depending on size and access.

Usually yes, though water is off for part of each day. The plumber explains the plan beforehand.

Not always. One leak can be fixed. Repeated leaks in the same run suggest the pipe is worn out.

It is gray plastic pipe installed roughly from 1978 to 1995. Its fittings are known to fail, so plan on replacement if you find it.

If the cause is clogged or corroded supply pipe, yes. Other causes, such as a failing pressure regulator, are checked first.

Our line at (314) 461-6239 is open 24/7 for emergencies. Repiping itself is booked as a planned job.

Ready to talk about repiping? Call a licensed plumber.

Call (314) 461-6239
Coverage area

Plumbing dispatch across Ballwin and west St. Louis County

Our 24/7 line covers Ballwin and the neighboring towns of Ellisville, Manchester, Town and Country, and Fenton.

Call now, 24/7: (314) 461-6239